Tutorial Material for Pro/ENGINEER Wildfire 2.0 pdf

MAE 244 : Dynamics and Strength Laboratory Fall 2005

Tutorial Material for

Pro/ENGINEER Wildfire 2.0

With Integrated Pro/MECHANICA

Tutorial 3: Modeling L-Shaped Rod and Performing

Finite Element Analysis using Pro/MECHANICA

Chuanyu Feng, PhD

[email protected]

MAE 244 : Dynamics / Strength Laboratory Fall 2005

Chuanyu “tony” Feng 2

Introduction

This tutorial is similar to Tutorial 2. The difference is that, in this part, you will use

Sweep feature to make an L-Shaped Rod, and then apply proper boundary conditions

and loads to analyze it.

Create an L-Shaped Rod

In this session, you will make a simple Pro/E part, and further practice the basic

modeling technique: sketching and sweep.

Starting Pro/E and Creating new Part

1. Start Pro/E Wildfire.

2. Click menu: File Æ New. A dialog will pop up (Figure 1)

3. Give a new name and/or description if desired.

4. Click OK button and Pro/E will create an empty solid part as shown in Figure 2.

Figure 1. “New” Dialog