Tài liệu CCIE-Lab-1 doc

1

Wichita State University

Department of Electrical and Computer Engineering

CCIE Preparation Laboratory

WSU CCIE Lab #1

Basic Multiprotocol Skills Lab

Version 3.01.2-324, 11-3-2000

NBMA Network

(Frame Relay)

Ring 2

Ring 1

R1

R5

R2

R3

R7

Backbone 3

E0 130.10.Y.5

VLAN 3

?? Configure the network using network 130.10.x.x

?? Use an 8 bit subnet mask unless otherwise specified

?? The address of the tftp server is 130.10.Y.2, where Y is the rack #

?? If a password is needed, use cisco for the password

Lab 1. Connect Terminal Server (30 minutes)

1. Setup routers as shown in the diagram above.

2. Document your network and include a diagram with all configured interfaces and all network

addresses.

3. Configure an ip host list on R5 for a reverse telnet session into each router.

Lab 2. IP (1 hour)

At the end of each exercise, verify connectivity between all ports:

?? All ip routes appearing in all routers

?? Ping from any interface to any other interface

Lab 2a

1. Configure R8 as a frame-relay switch.

2. Connect R1, R2, and R5 over Frame Relay. Configure R5 using subinterfaces. Configure R1

without using subinterfaces and using map commands. Configure R2 without using

subinterfaces or map commands. Use multiple subnets over the frame cloud. Use only 1 PVC

on R1 and R2.