How To Build Your Own Computer phần 4 potx

STEP 12 : Install Floppy Drive

1. Choose which drive bay you want to install the drive to and remove the

face plate off of that bay. Save the face plate for future use. Pick a bay

that will fit the drive. If you have to install a 3.5" drive in a 5.25" bay,

you'll have to use a special front panel to adapt it. This panel usually

comes with a new floppy drive.

2. Now, slide the drive into the bay from the front. If your particular case

has a drive rack, then you may need to remove the rack from the system

and then screw the drive into the rack separately from the actual case.

Otherwise, screw the drive into the case itself. Before doing so, make

sure the front of the drive is flush with the front of the PC.

3. If you are using brackets to hold the drive in place, secure them now.

You may need to temporarily disconnect the cables. Once in, tighten the

drive in place. Double-check the connections, also checking the

connections for other drives to make sure you didn't bump one out of

place.

4. Now, the floppy disk drive should be installed properly.

5. OPTIONAL : If you are installing a 3.5” internal ZIP drive, you install it

the same way and into the second floppy drive bay of your case.

This e-book is copyright to Glyn Williams. If you have purchased this book from elsewhere please e￾mail [email protected] for a reward